实验六:交换机的基本配置
实验目的：交换机的基本配置
实验地点：软件实验室3
实验时间：11月10日
实验者：12.5 29 庞佳慧
实验内容：
Ruijie#*Nov 10 16:20:27: %SYS-5-CONFIG_I: Configured from
console by console
Ruijie#ping 1.1.1.1
Sending 5, 100-byte ICMP Echoes to 1.1.1.1, timeout is 2
& press Ctrl+C to break &
Success rate is 0 percent (0/5)
Ruijie#ping 1.1.1.1
Sending 5, 100-byte ICMP Echoes to 1.1.1.1, timeout is 2
& press Ctrl+C to break &
Success rate is 0 percent (0/1)
Ruijie#conf t
Enter configuration commands, one per line.& End with
Ruijie(config)#hostname SW-1
SW-1(config)#banner motd $
Enter TEXT message.& End with the
character '$'.
welcom to SW-1,if you are admin,you can config
If you are not admin,please EXIT!
SW-1(config)#
SW-1(config)#exit
SW-1#*Nov 10 16:24:11: %SYS-5-CONFIG_I: Configured from
console by console
SW-1 CON0 is now available
Press RETURN to get started
welcom to SW-1,if you are admin,you can config
If you are not admin,please EXIT!
SW-1&enable
SW-1#conf t
Enter configuration commands, one per line.& End with
SW-1(config)#interface fastEthernet 0/1
SW-1(config-if-FastEthernet 0/1)#speed 10
SW-1(config-if-FastEthernet 0/1)#duplex half
SW-1(config-if-FastEthernet 0/1)#no shutdown
SW-1(config-if-FastEthernet 0/1)#description "This is a
Accessport."
SW-1(config-if-FastEthernet 0/1)#end
SW-1#*Nov 10 16:28:01: %SYS-5-CONFIG_I: Configured from
console by console
SW-1#show interface fastEthernet 0/1
Index(dec):1 (hex):1
FastEthernet 0/1 is DOWN& , line protocol is
Hardware is S2600I FastEthernet
Description: "This is a Accessport."
Interface address is: no ip address
MTU 1500 bytes, BW 10000 Kbit
Encapsulation protocol is Bridge, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
Rxload is 1/255, Txload is 1/255
Transmitted packets&&&&
Transmitted bytes&&&&&&
Dropped packets
Dropped bytes
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
1&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
2&&&&&&&&&&&&&&&&
&&&&0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
3&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
4&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
&&&&&&&&&&&&&&&&&&0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
6&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
7&&&&&&&&&&&&&&&&&&&&
4&&&&&&&&&&&&&&&&&&
440&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&
Switchport attributes:
interface's description:""This is a Accessport.""
admin medium-type is Copper, oper medium-type is Copper
lastchange time: 0 Day: 0 Hour: 0 Minute:30 Second
current status duration: 0 Day: 0 Hour:14 Minute:37
Priority is 0
admin duplex mode is Force Half Duplex, oper duplex is
admin speed is 10M, oper speed is Unknown
flow control admin status is OFF, flow control oper status is
admin negotiation mode is ON, oper negotiation state is
Storm Control: Broadcast is OFF, Multicast is OFF, Unicast is
Port-type: access
Vlan id: 1
5 minutes input rate 0 bits/sec, 0 packets/sec
5 minutes output rate 0 bits/sec, 0 packets/sec
4 packets input, 408 bytes, 0 no buffer, 0 dropped
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
4 packets output, 408 bytes, 0 underruns , 0 dropped
0 output errors, 0 collisions, 0 interface resets
SW-1#conf t
Enter configuration commands, one per line.& End with
SW-1(config)#interface fastEthernet 0/1
SW-1(config-if-FastEthernet 0/1)#default
description
SW-1(config-if-FastEthernet 0/1)#default
SW-1(config-if-FastEthernet 0/1)#default
description
SW-1(config-if-FastEthernet 0/1)#default duplex
SW-1(config-if-FastEthernet 0/1)#end
SW-1#*Nov 10 16:30:54: %SYS-5-CONFIG_I: Configured from
console by console
SW-1#show interface fastEthernet 0/1
Index(dec):1 (hex):1
FastEthernet 0/1 is DOWN& , line protocol is
Hardware is S2600I FastEthernet
Interface address is: no ip address
MTU 1500 bytes, BW 10000 Kbit
Encapsulation protocol is Bridge, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
Rxload is 1/255, Txload is 1/255
Transmitted packets&&&&
Transmitted bytes&&&&&&
Dropped packets
Dropped bytes
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
1&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
2&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
3&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
4&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&&&0
&&&&&&&&&&&&&
5&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
6&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
0&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
7&&&&&&&&&&&&&&&&&&&&
4&&&&&&&&&&&&&
&&&&&440&&&&&&&&&&&&&&&&&&&&
&&&&&&&&&&&&&
Switchport attributes:
interface's description:""
admin medium-type is Copper, oper medium-type is Copper
lastchange time: 0 Day: 0 Hour: 0 Minute:30 Second
current status duration: 0 Day: 0 Hour:17 Minute:44
Priority is 0
admin duplex mode is AUTO, oper duplex is Unknown
admin speed is 10M, oper speed is Unknown
flow control admin status is OFF, flow control oper status is
admin negotiation mode is ON, oper negotiation state is
Storm Control: Broadcast is OFF, Multicast is OFF, Unicast is
Port-type: access
Vlan id: 1
5 minutes input rate 0 bits/sec, 0 packets/sec
5 minutes output rate 0 bits/sec, 0 packets/sec
4 packets input, 408 bytes, 0 no buffer, 0 dropped
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
4 packets output, 408 bytes, 0 underruns , 0 dropped
0 output errors, 0 collisions, 0 interface resets
SW-1#show version
System description&&&&&
: Ruijie Gigabit Security & Intelligence Access Switch
S2628G-I) By Ruijie Networks
System start time&&&&&&
System uptime&&&&&&&&&&
: 0:0:18:38
System hardware version : 1.11
System software version : RGOS 10.4(3b16)
Release(151126)
System BOOT version&&&&
: 10.4(3b16) Release(151126)
System CTRL version&&&&
: 10.4(3b16) Release(151126)
System serial number&&&
: G1G813G008726
Device information:
Hardware version : 1.11
Software version : RGOS 10.4(3b16) Release(151126)
BOOT version&&&&
: 10.4(3b16) Release(151126)
CTRL version&&&&
: 10.4(3b16) Release(151126)
Serial number&&&
: G1G813G008726
SW-1#show running-config
Building configuration...
Current configuration : 1387 bytes
version RGOS 10.4(3b16) Release(151126)(Mon Dec 31
01:20:24 CST 2012 -ngcf64)
hostname SW-1
redundancy
&auto-sync time-period
&auto-sync
&switchover timeout
no service password-encryption
interface FastEthernet 0/1
interface FastEthernet 0/2
interface FastEthernet 0/3
interface FastEthernet 0/4
interface FastEthernet 0/5
interface FastEthernet 0/6
interface FastEthernet 0/7
interface FastEthernet 0/8
interface FastEthernet 0/9
interface FastEthernet 0/10
interface FastEthernet 0/11
interface FastEthernet 0/12
interface FastEthernet 0/13
interface FastEthernet 0/14
interface FastEthernet 0/15
interface FastEthernet 0/16
interface FastEthernet 0/17
interface FastEthernet 0/18
interface FastEthernet 0/19
interface FastEthernet 0/20
interface FastEthernet 0/21
interface FastEthernet 0/22
interface FastEthernet 0/23
interface FastEthernet 0/24
interface GigabitEthernet 0/25
interface GigabitEthernet 0/26
interface GigabitEthernet 0/27
interface GigabitEthernet 0/28
line con 0
line vty 0 4
banner motd ^C
welcom to SW-1,if you are admin,you can config
If you are not admin,please EXIT!
SW-1#copy running-config startup-config
[Message : Command is forbidden]
SW-1#write memory
[Message : Command is forbidden]
SW-1#write
[Message : Command is forbidden]
最后几条语句没有实现,可能是因为系统配置或者权限的问题.
已投稿到：
以上网友发言只代表其个人观点，不代表新浪网的观点或立场。思科3550交换机24口的数据：5 minute input rate
bits/sec, 6605 packets/sec_百度知道5分钟内用了多少带宽？交换机上的数据是5 minute input rate
bits/sec, 6539 packets/sec_百度知道5 minute input rate
bits/sec, 2830 packets/sec_百度知道计算机网络实验_图文_百度文库
两大类热门资源免费畅读
续费一年阅读会员，立省24元！
计算机网络实验
上传于||暂无简介
阅读已结束，如果下载本文需要使用0下载券
想免费下载更多文档？
定制HR最喜欢的简历
下载文档到电脑，查找使用更方便
还剩34页未读，继续阅读
定制HR最喜欢的简历
你可能喜欢}